Asset Bug - View Task

Description
Instructions	Note: almost 3 quarts undrainable, flushing is easy with drain open and water forced in cap 1. Park the car on level ground, set the parking brake and remove the radiator cap when cool. 2. Wrap a thick cloth around the radiator cap and slowly turn the radiator cap counterclockwise without pressing down on it, until it stops. This relieves any pressure remaining in the cooling system. When you are sure that all the pressure has been released, remove the radiator cap by pushing down and turning counterclockwise. 3. Be sure your drain receptacle is in place. Open the drain cock on the radiator. 4. Flush with water through radiator cap. 5. Add 85 fl. oz. of pure antifreeze (not pre-mixed). 5. Slowly fill the radiator with the pure coolant until the fluid level stays up in the radiator neck. And pump the radiator hose in order to bleed the air. 6. Run the engine at idle until the coolant circulates. If the cooling fan operates and the coolant starts to circulate, add the coolant to the reservoir. 7. To bleed the air in the cooling system, repeat procedure 6 until the cooling fan operates 3~5 times. When you run out of pure antifreeze, start to add water. 8. Replace the radiator cap and turn it until tightly installed. 9. Stop the engine and check the coolant level when the engine is cool. The level of the coolant should be the "L" and "F" lines on the reservoir. If the level is below the "L" line, repeat the procedure 4~8 until the level between "L" and "F". 10.Replace the reservoir cap and check to be sure the drain cock and the radiator cap are fully closed and not leaking. 2.4L : 6.66qt (213.12 oz) 3.3L : 8.66qt 5F (-15C) 35% AF (65% H20) is 74.6 oz AF -13F (-25C) 40% AF (85 oz of AF) -31F (-35C) 50% AF -49F (-45C) 60% AF
Task Type
	Takes asset out of service
Priority
Estimate	Hours

Part	Quantity
Coolant	85	fl. oz.

Triggers	Whichever comes first
By Meter	Every Miles
Starting At	Miles
By Time	Every
Starting At	Months
Limit	occurences

No public attachments